Some news about ordering at iTeadStudio.com

A short update, hoping it could answer some questions people are asking themselves. This time, I ordered two different boards. One 15x10cm and one 5x5cm. I placed the order and uploaded my gerbers the 4/11/2011. As I had two different boards, I named the zips containing the gerbers with the size of the board (“10x15cm” and “5x5cm”). The shipment mail came the 11/11/2011 and the package the 18/11/2011. This time, it was sent with HK post registered airmail with a tracking number. Unfortunately, the tracking isn’t as good as the one with Chinapost (at least, with France as destination. I only had “the item left HK”). But it was fast. Also cheap, because they put the two board sets in the same box, so I only paid one dollar more (same price as one batch of 5×5 PCBs)

The small PCB had twice the same design. It seems to be OK, as long as you don’t put anything that eases the board cut (slots, holes line or V-groove):

USB Temperature Logger PCB Top

As usual (so far) the fabrication quality is excellent for the price.

USB Temperature Logger PCB Bottom

You’ll notice the slots for the USB plug. I’m using Altium and when a board has slots, it generates a separate drill file for them. I included the two files (round holes and slots) in my zip and apparently the fab managed to figure out what to do with them. Cool.

I used 0,15mm lines for some silkscreen (the rectangle around the tiny temperature sensor package). I see I should rather use 0,2mm lines instead, like for the other lines. The tracks, vias and separations have the same size like before (see my previous notes about iTeadStudio). I soldered the components, everything worked fine (at least mechanically). Except that one of the regulator packages is wrong, should be SOT233. Argh. Stupid me. (Well, better too big than too small.)

The 10x15cm PCB is a 16 input, SNMP state output board. You can configure each input to be pull-up, pull-down or current loop —active. Each input is opto-isolated, plus MOV and fuse protected. A web page allows you to configure the board (IP,SNMP and inputs), display the inputs state and the embedded temperature sensor reading. Then, you get the inputs state by SNMP polling or traps. I’ve been working on this for quite some time and it’s really cool.

I had one board extra (cool, especially I’ll use all of them this time) and I took the 100% e-test option. One board has a small offset in the holes, but still within the specs.

SNMP 16 Inputs Supervision PCB Bottom

I’ll try to make a separate post about this board if I have time.